⬢ DragonFlyBSD Kernel Audit
DF-5616 / run.log
← back to finding ↓ download raw
--- vmstat -i BEFORE ---
interrupt                    total       rate
acpi0                            0          0
psm0                             0          0
virtio_pci0                      0          0
virtio_pci1                    107          3
swi_siopoll                    126          4
swi_vm                           0          0
atkbd0                           0          0
virtio_pci0                    143          4
virtio_pci1                    712         23
ata0                             0          0
virtio_pci0                    137          4
virtio_pci1                    110          3
ata1                            45          1
virtio_pci1                    309         10
swi_cambio                      40          1
sio0                           320         10
virtio_pci1                     47          1
virtio_pci1                     57          1
swi_taskq/swi_mp_taskq          60          2
Total                         2213         73
--- kldload ---
--- console messages captured via dmesg ---
sio2: can't drain, serial port might not exist, disabling
hpt27xx: no controller detected.
CAM: Configuring 2 busses
CAM: finished configuring all busses
cd0 at ata1 bus 0 target 0 lun 0
cd0: <QEMU QEMU DVD-ROM 2.5+> Removable CD-ROM SCSI-0 device 
cd0: 16.000MB/s transfers
cd0: Attempt to query device size failed: NOT READY, Medium not present
Mounting root from hammer2:vbd0s1d
hammer2_mount: root devstr="vbd0s1d"
hammer2_mount: device="vbd0s1d" label="ROOT" rdonly=1
hammer2_ondisk: "/dev/vbd0s1d" zone=2 id=0 offset=0x0000000000000000 size=0x000000063f000000
hammer2_mount: hmp=0xfffff8008fae0000 pmp=0xfffff80090280000
DMA space used: 13580k, remaining available: 131072k
Mounting devfs
hammer2_mount: "vbd0s1d": no recovery needed
hammer2: enable read/write
HAMMER2: VOLDATA DUMP
HAMMER2: INITIATE SPANs
swap low/high-water marks set to 41940/62910
D0: ncpu=6 mycpuid=5 MachIntrABI.type=2 (MACHINTR_ICU=1)
D1: icu_imen(shadow)=fffb hw_imr=fffb coherent=YES
D2: ELCR=0c00 (bit=1 -> level)
P3: (uint8_t)~(1 << -1) = 0xff (C99 UB shift; x86: 1<<31)
P3: (uint8_t)~(1 << 3)  = 0xf7 (well-defined case)
P2: irq0 mask-cycle IMR1 fb(en-dis path) -> fa -> fb; shadow now fffb; ELCR 0c00->0c00 persist=YES
P5: ICU2 ICW cycle, ELCR_HI 0c -> 0c (persists across ICW)
P4: ioapic_enable=1 icu_ioapic_extint(-1,0x20)=0 IMR1_after=0xff (expect 0xff: all-masked, benign) shadow_untouched=YES
P4: restored IMR={fb,ff} want={fb,ff} shadow=fffb ELCR 0c00->0c00->0c00
P6: alive, ticks delta=199 (want >=2); final icu_imen=fffb hw=fffb coherent=YES
--- vmstat -i AFTER ---
interrupt                    total       rate
acpi0                            0          0
psm0                             0          0
virtio_pci0                      0          0
virtio_pci1                    107          3
swi_siopoll                    126          3
swi_vm                           0          0
atkbd0                           0          0
virtio_pci0                    148          4
virtio_pci1                    716         21
ata0                             0          0
virtio_pci0                    142          4
virtio_pci1                    110          3
ata1                            45          1
virtio_pci1                    309          9
swi_cambio                      40          1
sio0                           961         29
virtio_pci1                     47          1
virtio_pci1                     57          1
swi_taskq/swi_mp_taskq          60          1
Total                         2868         86
RUN-OK guest still up:  5:54PM  up 33 secs, 0 users, load averages: 0.15, 0.04, 0.01