KLDLOADED
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
interrupt uses mplock: psm0
psm0: model IntelliMouse Explorer, device ID 4
sio0: <16550A-compatible COM port> port 0x3f8-0x3ff irq 4 on acpi0
sio0: type 16550A, console
ACPI: Enabled 2 GPEs in block 00 to 0F
rdrand0: No RdRand support.
orm0: <ISA Option ROM> at iomem 0xe8000-0xeffff on isa1
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa1
sio2: can't drain, serial port might not exist, disabling
hpt27xx: no controller detected.
CAM: Configuring 2 busses
CAM: finished configuring all busses
cd0 at ata1 bus 0 target 0 lun 0
cd0: <QEMU QEMU DVD-ROM 2.5+> Removable CD-ROM SCSI-0 device 
cd0: 16.000MB/s transfers
cd0: Attempt to query device size failed: NOT READY, Medium not present
Mounting root from hammer2:vbd0s1d
hammer2_mount: root devstr="vbd0s1d"
hammer2_mount: device="vbd0s1d" label="ROOT" rdonly=1
hammer2_ondisk: "/dev/vbd0s1d" zone=2 id=0 offset=0x0000000000000000 size=0x000000063f000000
hammer2_mount: hmp=0xfffff8008fae0000 pmp=0xfffff80090280000
DMA space used: 13580k, remaining available: 131072k
Mounting devfs
hammer2_mount: "vbd0s1d": no recovery needed
hammer2: enable read/write
HAMMER2: VOLDATA DUMP
HAMMER2: INITIATE SPANs
swap low/high-water marks set to 41940/62910
HARNESS: loaded (real uvc sources compiled in)
HARNESS[1] DF-5305: parse_ctrl ret=0 sc.data=0xfffff8004f164300 blob=0xfffff8004f1839e0 blob_end=0xfffff8004f183a24
HARNESS[1] DF-5305: nfmt=1 nfrm=0 nitv=0 fmt=0xfffff8004f1ae0a0
HARNESS fmt[0].name hex:
  c1 c2 c3 c4 c5 c6 c7 c8 c9 ca cb cc cd ce cf d0
  55 55 55 55 55 55 55 00 00 00 00 00 00 00 00 00
  00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
  00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
HARNESS[1] DF-5305: name strlen=23; in-bounds non-NUL run after GUID start (blob+45) is 23 bytes -> strlen > 23 PROVES read past the 68-byte cdesc allocation
HARNESS[1] DF-5305: uvc_drv_enum_v4l2_fmt ret=0 -> user-visible description=<M-AM-BM-CM-DM-EM-FM-GM-HM-IM-JM-KM-LM-MM-NM-OM-PUUUUUUU>